SonTek, a Xylem brand
RiverSurveyor S5/M9 System Manual (February 2013)
137
Island Edge: Select to insert an island in the measurement section
Figure 123. Station Dialog
Press the Measure button to begin collecting data, Cancel to go back to review the measured
station information, or End Edge to input the end edge location information. If you press Cancel
to go back, you must press Next Station (F5) in the upper left hand corner of the window to pro-
ceed with the measurement.
Once the station measurement is complete, a Measurement Results dialog (shown in Figure
124) will automatically display a summary of the measurement. Review this information and
then press Accept to proceed to the next station or Repeat to measure the same station again.
To Next Page
Loading...
