7.2 Restoring Factory Default State
In some cases, you may need to restore your Yakumo deltaX GPS to the factory
default state by clearing the memory (RAM) from your Yakumo deltaX GPS.
For example, you should clear the memory:
When your Yakumo deltaX GPS does not respond after being reset.
When you forget your password.
Clearing the memory means all data you have entered in RAM, including all
files, system settings and additional programs you have installed, will be erased.
(Programs installed to ROM at the factory are not affected.)
CAUTION:
To ensure the integrity of your data should it be necessary to clear the memory, you’re
advised to regularly back up your data. (For more information on backing up data, see
section 3.5.)
Do not slide the ON/OFF Switch unless it is necessary.
Follow this procedure to clear the memory from your Yakumo deltaX GPS:
1. Backup your information if necessary.
2. Disconnect all cables, including the AC adapter, from your Yakumo deltaX
GPS.
3. Stop all running programs by tapping
Settings System tab
Memory icon Running Programs tab Stop All.
4. Use the stylus to slide the ON/OFF switch to
the OFF (up) position.
5. Wait for 1 minute and then slide the switch
back to the ON (down) position.
6. Your Yakumo deltaX GPS will automatically
turn on and prompt you to start the setup
wizard.
7. Follow the onscreen instructions to complete
the setup wizard.
8. Reestablish a. partnership with your desktop
computer.
90
To Next Page
Loading...
General