3. If you need to enter specific server information, tap the appropriate adapter
and then
Properties. Most networks use DHCP, so you should not have to
change these settings unless your network administrator instructs you to do
so.
4. If necessary, connect the network card to the network by using a network
cable.
NOTE: You may need proxy server and VPN connection settings. For more information,
see Yakumo deltaX GPS online help and your network administrator.
Starting and Ending a Network Card Connection
To start the connection, install the network card and connect the network cable.
Then, use the desired program. For example, switch to Pocket Internet Explorer
and browse to a Web page. Your Yakumo deltaX GPS will automatically
connect.
To end the connection, remove the card from your Yakumo deltaX GPS.
Wireless Network Connection
Use a wireless network card to connect to a wireless network without physical
cables.
Before creating the connection, you need to:
Have a wireless network card (SD IO). (For installation information, see the
documentation supplied with the product.)
If necessary, obtain the authentication information from your network
administrator.
Creating a Wireless Connection to a Network
Networks that you have already configured are preferred networks and are listed
in Wireless networks. You can select to connect to only preferred networks or
have your Yakumo deltaX GPS search for and connect to any available network
whether it is preferred or not.
1. Insert the wireless network card into your Yakumo deltaX GPS. (For
information, see the documentation that came with the product.)
79
To Next Page
Loading...
General