Entering the User Menu
Under the “Alarm off” condition,
user can access the user menu via
entering a valid user code.
Press any key to wake up the
panel’s keypad, and proceed to
enter the user pincode. when the
first numberic key is pressed, the
display will show:
enter code
*.....
Enter the 4 or 6 digit pincodes
followed by OK within 30 seconds.
The options for the user menu
.Fault List
Hear answer mc
full arm
part arm #1
lone occupant
set time/date
bypass sensors
RSps/ilps/ZE88
event log
change pincode
gsm
master setup
Notes:
1) Fault List is only shown if there is
a fault event in the system
2) Selection shown will depends on
User attribute setting.
3) Part Arm 2 and 3 will be shown if
enabled.
4) RSPS/ILPS/ZE88 and GSM will
only be shown if the relevant device
exists in the system.
5) If a Master pincode was used, the
option Master Setup will be shown.
6) Hear Answer MC (Machine) is only
shown if there the Answer Machine
is enabled, and there is a message
in memory.
7) For system with 2 Areas defined,
a user with access to both areas
will need to first choose the area
specific user menu. Press 1 for Area
1 and 2 for Area 2.
a1:off, a2:off
1 for a1 menu
4
To Next Page
Loading...
Need help?
General
