Yale SmartHome Alarm series User Manual

Force Arming
Force Arming allows the user to
full arm or part arm (lone occupant
mode included) the system with a
Fault condition present.
Where possible, please rectify the
fault before arming. The system will
prevent you from arming normally
when a fault is present (except
device/panel low battery), and the
user will need to carry out another
step in order to force arm the area.
To force arm the system:
Arm the system normally via keyfob,
keypad or the control panel. The
Control Panel will emit a warning
sound to indicate faults and the
panel screen will scroll through all
the faults one by one.
For keypad and keyfob, arm the
system for a second time within 30
seconds of the first attempt. The
system is now forced arm.
For control panel, press OK and
the system will prompt you for your
pincode. Press ok and the following
display will be shown:
force arm
(OK?)
Press OK to confirm. The defined
timer starts to Count Down. Please
note for Lone occupant mode it will
be 300 seconds.
time to exit
30 sec
When the Exit Delay timer expires,
the Control Panel will emit a long
beep and the system is now in the
designated Arm Mode.
Arming with door opened
If the user tries to arm the system
while a door contact is opened,the
Control Panel will emit a warning
sound to indicate faults and the
panel screen will display the
following screens:
fault dsp
10:39 jan 29
door opened
DC Z01
If the door/window is shut
immediately, the fault on screen will
be cleared and the system will revert
to alarm off mode. The system can
now be armed normally.
Should you wish to arm the system
with the door contact being open,
follow the steps described in the
Force Arming section for operation.
9

Yale SmartHome Alarm series Specifications

General

Brand	Yale
Model	SmartHome Alarm series
Category	Security System
Language	English