Yale SmartHome Alarm series User Manual

Full Arm
The Full Arm mode is intended
for fully arming the property when
there are no occupants. If Area 2 is
defined, the system may ask you to
choose one of the areas for arming
(if the user have access to both
areas). To full arm the system:
Keyfob- Press full arm
Keypad- Enter pincode follow by
pressing full arm.
Control panel- In Alarm off mode,
enter pincode and press ok. Select
Full arm and press ok; or press
“0” to full arm the system. On the
screen it will show:
time to exit
30 sec
When the entry delay time expires,
the control panel will emit a long
beep. The LCD will display an Alarm
On message and the system is now
in the full arm mode. If the Final
Door option is enabled, the system
will immediately arm when the door
contact (delay attribute) is closed,
i.e. user left the property.
Stop Entry Delay
During the entry countdown, the
user can prevent the system from
sounding and reporting by:
Keyfob- Press disarm
Keypad- Enter pincode follow by
pressing disarm.
Control panel- Enter pincode and
press OK.
Stop Exit Delay
During the exit countdown, user can
prevent the system from arming by:
Keyfob- Press disarm
Keypad- Enter pincode follow by
pressing disarm.
Control panel- Press return key.
Enter pincode and press OK.
Extend Exit Delay
During the exit countdown, user can
extend the Exit Delay by:
Keyfob- Press full arm
Keypad- Enter pincode follow by
pressing full arm.
*Each time this is done, the delay
time will start counting from the
beginning.
Disarm the system
When the full arm mode is set, you
can disarm the system by:
Keyfob- Press disarm
Keypad- Enter pincode follow by
pressing disarm.
Control panel- Enter pincode and
press OK.
7

Yale SmartHome Alarm series Specifications

General

Brand	Yale
Model	SmartHome Alarm series
Category	Security System
Language	English