20
ADJUSTING METHOD
Operations should be made while watching the information on this unit’s display.
If you are using the remote control transmitter, set the
SELECTOR DIAL to the AMP/TUN or DSP position on the
remote control transmitter.
or
1 Turn the power on.
Front panel Remote control
or
2 Press SET MENU once or more to select the title
“1. CNTR” (so that “CNTR” appears on the display).
Front panel Remote control
or
* After pressing SET MENU once on the remote control
transmitter, you can also select the title by pressing
.
(Pressing
goes back one selection.)
Appears.
3 Press + or – once or more to select the position you
want.
Front panel Remote control
or
Changes.
4 Repeat steps 2 and 3 to change selections on
“2. REAR”, “3. MAIN”, “4. BASS” and/or “5. M.LVL” in
the same way.
1 2 3
1
2
3
DSP-A595-2 3/25/99, 3:53 PM20
To Next Page
Loading...
Need help?
General
