33
English
1
2
2 Press + or – to adjust the settings for delay time or
speaker output levels.
Front panel Remote control
or
3 Repeat steps 1 to 3 to adjust settings on any other
item.
ADJUSTING DELAY TIME AND SPEAKER OUTPUT LEVELS
When using the digital sound field processor including the Dolby Pro Logic Surround decoder or the Dolby Digital decoder, you can
adjust the delay time between the main sound and effect sound, and each speaker’s output level as you prefer.
Adjusting method
If you are using the remote control transmitter, set the
SELECTOR DIAL to the AMP/TUN or DSP position on the
remote control transmitter.
or
1 Press TIME/LEVEL once or more until the name of item
which you want to adjust appears on the display.
Front panel Remote control
or
* After pressing TIME/LEVEL once on the remote control
transmitter, you can also select the name of item by
pressing
.
When pressed, the selection changes as follows:
DELAY
CENTER
R SUR.
L SUR.
SWFR
* Pressing on the remote control transmitter changes the
selection in the reverse order.
* Depending on the mode of this unit, you cannot select all
items.
2
1
Delay time
Center speaker output level
Right rear speaker output level
Left rear speaker output level
Subwoofer output level
DSP-A595-4 3/25/99, 3:54 PM33
To Next Page
Loading...
Need help?
General
