E-62
SET MENU ITEMS
15 DISPLAY SET
Use this feature to set the background and the location of the OSD, and the brightness of this unit’s front panel display.
■ DIMMER
You can adjust the brightness of the front panel display.
Control range: –4 – 0
Initial setting: 0
■ OSD SHIFT (OSD off-set position)
This setting is used to adjust the vertical position of the OSD.
Control range: +5 (downward) – –5 (upward)
Initial setting: 0
Press + to lower the position of the OSD. Press – to raise the position of the OSD.
■ BLUE BACK
This item sets the OSD background.
Choices: AUTO, OFF
Initial setting: AUTO
AUTO: Blue background is displayed when no video signal is being input.
OFF: Nothing is displayed when no video signal is being input.
Caution
• With “OFF” selected, no on-screen display is shown on the video monitor when no
video signal is being input.
16 MEMORY GUARD
Use this feature to prevent accidental changes to DSP program parameter values and other settings on this unit.
Initial setting: OFF
Select “ON” to protect the following features:
• DSP program parameters
• All SET MENU items except “16 MEMORY GUARD”
• Center, front effect, rear speakers, rear center, and subwoofer levels
• The on-screen display (OSD) mode
Cautions
• When “16 MEMORY GUARD” is set to “ON”, you cannot select any other SET MENU
items.
• When “16 MEMORY GUARD” is set to “ON”, you cannot use the test tone.
15 DISPLAY SET
≥ DIMMER………………………0
OSD SHIFT………………0
BLUE BACK………AUTO
16 MEMORY GUARD
“OFF ON
-/+ : Select
/ : Exit
To Next Page
Loading...
Need help?
General
