Yamaha F25D - Specifications and requirements; Engine and Performance Specifications

10
Specifications and requirements
EMU34520
Specifications
TIP:
“(AL)” stated in the specification data below
represents the numerical value for the alumi-
num propeller installed.
Likewise, “(SUS)” represents the value for
stainless steel propeller installed and “(PL)”
for plastic propeller installed.
TIP:
“*” means, select the engine oil referring to
the chart of engine oil paragraph. For further
information, see page 13.
EMU2821J
Dimension:
Overall length:
F25DEHT 1181 mm (46.5 in)
F25DET 724 mm (28.5 in)
F25DMH 1181 mm (46.5 in)
FT25FET 735 mm (28.9 in)
Overall width:
398 mm (15.7 in)
Overall height L:
F25DEHT 1284 mm (50.6 in)
F25DET 1283 mm (50.5 in)
F25DMH 1284 mm (50.6 in)
FT25FET 1312 mm (51.7 in)
Overall height X:
1426 mm (56.1 in)
Transom height L:
F25DEHT 550 mm (21.7 in)
F25DET 550 mm (21.7 in)
F25DMH 550 mm (21.7 in)
FT25FET 536 mm (21.1 in)
Transom height X:
650 mm (25.6 in)
Weight (AL) L:
F25DEHT 86.0 kg (190 lb)
F25DET 82.0 kg (181 lb)
F25DMH 78.0 kg (172 lb)
FT25FET 92.0 kg (203 lb)
Weight (AL) X:
94.0 kg (207 lb)
Performance:
Full throttle operating range:
5000–6000 r/min
Maximum output:
18.4 kW@5500 r/min
(25 HP@5500 r/min)
Idle speed (in neutral):
975 ±50 r/min
Engine:
Type:
4-stroke L
Displacement:
498.0 cm
3
Bore × stroke:
65.0 × 75.0 mm (2.56 × 2.95 in)
Ignition system:
CDI
Spark plug with resistor (NGK):
DPR6EB-9
Spark plug gap:
0.8–0.9 mm (0.031–0.035 in)
Control system:
F25DEHT Tiller handle
F25DET Remote control
F25DMH Tiller handle
FT25FET Remote control
Starting system:
F25DEHT Electric starter
F25DET Electric starter
F25DMH Manual starter
FT25FET Electric starter
Starting carburetion system:
Prime start
Valve clearance (cold engine) IN:
0.15–0.25 mm (0.0059–0.0098 in)
Valve clearance (cold engine) EX:
0.25–0.35 mm (0.0098–0.0138 in)
Min. cold cranking amps (CCA/EN):
6BP-9-22-1E0.book 10 ページ ２０１０年２月９日 火曜日 午後３時５９分