Operation
54
EMU33121
Procedure for tilting down (power
trim and tilt models)
1. Push the power trim and tilt switch “ ”
(up) until the outboard motor is support-
ed by the tilt rod and the tilt support knob
becomes free.
2. Pull out the tilt support knob.
3. Push the power trim and tilt switch “ ”
(down) to lower the outboard motor to
the desired position.
EMU28061
Shallow water
EMU28073
Cruising in shallow water (manual tilt
models)
EWM01781
● Run the boat at the lowest possible
speed when using the shallow water
cruising system. The tilt lock mecha-
nism does not work while the shallow
water cruising system is being used.
Hitting an underwater obstacle could
cause the outboard motor to lift out of
the water, resulting in loss of control.
● Use extra care when operating in re-
verse. Too much reverse thrust can
cause the outboard motor to lift out of
the water, increasing the chance of ac-
cident and personal injury.
ECM00260
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
6BP-9-22-1E0.book 54 ページ ２０１０年２月９日 火曜日 午後３時５９分
To Next Page
Loading...
