Operation
56
EMU32913
Procedure for power trim and tilt models
1. Place the remote control lever / gear
shift lever in neutral.
2. Slightly tilt the outboard motor up to the
desired position using the power trim
and tilt switch. WARNING! Using the
power trim and tilt switch on the bot-
tom cowling while the boat is moving
or engine is on could increase the
risk of falling overboard and could
distract the operator, increasing the
risk of collision with another boat or
an obstacle.
[EWM01850]
3. To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch and slowly tilt the out-
board motor down.
EMU28195
Cruising in other conditions
Cruising in salt water
After operating in salt water, flush the cooling
water passages with fresh water to prevent
them from becoming clogged. Also rinse the
outside of the outboard motor with fresh wa-
6BP-9-22-1E0.book 56 ページ ２０１０年２月９日 火曜日 午後３時５９分
To Next Page
