Maintenance
60
sufficient, engine seizure may occur.
[ECM00291]
5. Run the engine at a fast idle for a few
minutes in neutral position. WARNING!
Do not touch or remove electrical
parts when starting or during opera-
tion. Keep hands, hair, and clothes
away from the flywheel and other ro-
tating parts while the engine is run-
ning.
[EWM00091]
6. Just prior to turning off the engine, quick-
ly spray “Fogging Oil” on to the silencer
cover. When properly done, the engine
will almost stall.
If the “Fogging Oil” is not available, run the
engine at idle speed until the fuel system be-
comes empty and the engine stops. Remove
the spark plugs and turn the flywheel magnet
several times with starter motor or by pulling
the manual starter handle to coat the cylinder
wall with oil.
7. Remove the outboard motor from the
test tank.
8. Drain the cooling water completely out of
the motor. Clean the body thoroughly.
9. Install the top cowling.
10. Store the fuel tank in a dry, well-ventilat-
ed place, not in direct sunlight.
EMU28402
Lubrication
1. Install the spark plug(s) and torque to
proper specification. For information on
spark plug installation, see page 68.
2. Change the gear oil. For instructions,
see page 74. Inspect the oil for the pres-
ence of water that indicates a leaky seal.
Seal replacement should be performed
by an authorized Yamaha dealer prior to
1. Water surface
2. Lowest water level
6BP-9-22-1E0.book 60 ページ ２０１０年２月９日 火曜日 午後３時５９分
To Next Page
Loading...
