Operation
43
4. Push the starter button to start the en-
gine.
5. Immediately after the engine starts, re-
lease the starter button and allow it to re-
turn to its original position. NOTICE:
Never push the starter button while
the engine is running. Do not keep
the starter motor turning for more
than 5 seconds. If the starter motor is
turned continuously for more than 5
seconds, the battery will be quickly
discharged, thus making it impossi-
ble to start the engine. The starter can
also be damaged. If the engine will
not start after 5 seconds of cranking,
release the starter button, wait 10
seconds, then crank the engine
again.
[ECM00161]
● When the engine is cold, it needs to be
warmed up. For further information, see
page 45.
● If the engine is warm and fails to start,
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 79.
6. Slowly return the throttle grip to the fully
closed position.
EMU27664
Electric start and remote control models
EWM01840
● Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-
off cord to a secure place on your cloth-
ing, or your arm or leg while operating.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
● Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. Place the remote control lever in neutral.
The start-in-gear protection device prevents
the engine from starting except when in neu-
6BP-9-22-1E0.book 43 ページ ２０１０年２月９日 火曜日 午後３時５９分
To Next Page
Loading...
