Yamaha HTR-5540 User Manual (English)

Other manuals for Yamaha HTR-5540

Questions and Answers:

C
Calvin ButlerAug 26, 2025
What to do if the sound suddenly goes off on my Yamaha Stereo Receiver?
- N
  Nicole NewmanAug 26, 2025
  If the sound from your Yamaha Stereo Receiver suddenly cuts off, it could be due to these reasons: * The protection circuit may have been activated due to a short circuit. Check that the IMPEDANCE SELECTOR switch is in the correct position and turn the unit back on. * The speaker wires may be touching each other. Ensure they are not, and then turn the unit back on. * The sleep timer may have activated. Turn the power back on and play the source again. * The sound may be muted. Press the MUTE button or any other operation button to cancel the mute function.
K
Karen MccartyAug 25, 2025
What to do if my Yamaha Stereo Receiver has no sound?
- K
  Karen JonesAug 26, 2025
  If your Yamaha Stereo Receiver isn't producing any sound, there are several things to check: * Ensure all input and output cables are correctly connected and not defective. * Select the appropriate input source using the INPUT l / h, 6CH INPUT, or the input selector buttons. * Verify that the speaker connections are secure. * Increase the volume and ensure the unit is not muted by pressing MUTE or any operation buttons to cancel mute.
A
ambermartinezAug 25, 2025
What to do if my Yamaha HTR-5540 Receiver sound suddenly goes off?
- D
  Dr. Jeffrey CarterAug 25, 2025
  If the sound on your Yamaha Receiver suddenly goes off, it could be due to: * Activation of the protection circuit because of a short circuit. Check that the IMPEDANCE SELECTOR switch is set to the appropriate position and then turn the unit back on. * The sleep timer may have activated. Turn the power back on and play the source again. * The sound might be muted. Press MUTE or any operation buttons to cancel the mute and adjust the volume.

Yamaha HTR-5540 Specifications

General

Tuner	AM/FM
Weight	22.1 lbs
Signal-To-Noise Ratio	100 dB
Total Harmonic Distortion	0.06%
Input Impedance	47 kOhm
Input Sensitivity	200 mV
Surround Sound	Dolby Digital, DTS, Dolby Pro Logic II
Digital Audio Inputs	2 x Optical, 1 x Coaxial
Video Inputs	3 Composite
Video Outputs	1 composite video output
Response Bandwidth	10 Hz - 100 kHz
Audio D/A Converter	24-bit / 96 kHz
Built-in Decoders	Dolby Digital, DTS, Dolby Pro Logic II
Surround Sound Effects	Virtual Cinema DSP
Dimensions (W x H x D)	17-1/8" x 6-3/8" x 15-1/4"
Amplifier Output Details	75 W - 8 Ohm - 20 Hz to 20 kHz - THD 0.06% - 5 channel(s) (surround)