Yamaha MIXING CONSOLE - Page 207

MIDI Remote Layer 207
01V96—Owner’s Manual
Remote Control
17
changing values in the range of 00 to 7F (0–127 in decimal) are
output.
9 Move the cursor to the LATCH/UNLATCH button, then press [ENTER] to
select LATCH or UNLATCH depending on how you want the [ON] buttons
to function.
• LATCH...........................Pressing the [ON] buttons repeatedly transmits alternating On
and Off messages.
• UNLATCH....................Pressing and holding down the [ON] buttons transmits On
messages, and releasing the [ON] buttons transmits Off mes-
sages.
■ When “SW” is assigned:
-LATCH
- UNLATCH
■ When “SW” is not assigned:
- UNLATCH
Tip: If “SW” is not assigned in the DATA parameter boxes of the ON section, the current MIDI
messages are output.
Note: Be sure to set one of the DATA parameter boxes of the FADER section to “FAD.” If no
“FAD” is assigned, fader operation is ignored.
Tip: Refer to the diagrams below for information on how the [ON] buttons behave when Latch
or Unlatch is selected.
Tip: In most situations, select Unlatch if SW is not assigned.
Off Illuminated Off
MIDI data transmission
(SW=7F)
MIDI data transmission
(SW=00)
Off Off
MIDI data transmission
(SW=7F)
MIDI data transmission
(SW=00)
Illuminated
MIDI data transmission
Off OffIlluminated