Setting Aux Send Levels 115
01V96—Owner’s Manual
Aux Outs
9
•Variable Mode
In this mode, Aux Send levels are variable and the signal source point can be either pre-fader
or post-fader. Channel Send level rotary controls and PRE/POST buttons appear on the
screen.
4 If you switched to Fixed mode in Step 3, the ON/OFF buttons turn each Input
Channel on or off for the currently-selected Aux Send.
Tip: You can select Variable or Fixed mode individually for each of the eight Aux.
Note:
•In Fixed mode, all ON/OFF buttons are turned OFF.
• When you switch to Variable mode, the signal source points are set to post-fader (PRE/POST
buttons are set to POST), and Send level rotary controls are reset to –∞.
Note: In Fixed mode, the Aux On/Off parameters for paired Input Channels are not linked
to each other.
To Next Page