Yamaha RM1x - Page 124

SONG MODE
124 RM1x SEQUENCE REMIXER
To Select a Job
Same as in the PATTERN mode. Refer to page 81.
CAUTION !
Do not turn off the power while a job is executing (while the “Executing...” message is on the screen), as this may cause
destruction of your recorded data.
❏ Undo/Redo
Job 00 Undo/Redo
Same as in the PATTERN mode. Refer to page 82.
❏ Note
Job 01 Quantize
Essentially the same as in the PATTERN mode except that a
TRACK is selected rather than a PHRASE, and the selectable
measure range is greater. Refer to page 82.
Job 02 Modify Velocity
Essentially the same as in the PATTERN mode except that a
TRACK is selected rather than a PHRASE, and the selectable
measure range is greater. Refer to page 84.
Job 03 Modify Gate Time
Essentially the same as in the PATTERN mode except that a
TRACK is selected rather than a PHRASE, and the selectable
measure range is greater. Refer to page 85.
12. Job
Parameter Values Function
Category UNDO/REDO, NOTE, EVENT, Selects the category.
MEASURE, TRACK, SONG
Job 00 ... 28 Selects the job.
Select Jumps to the job currently selected in the job list.