56 RM1x SEQUENCE REMIXER
PATTERN MODE
Recording the Grid Groove Settings
The grid groove settings can actually be merged into the se-
quence data as follows.
1 Make the Grid Groove settings as described above.
2 Press the [PATTERN] button to go to the Pattern play-
back mode.
3 Press the REC e button to engage the record
standby mode.
4 Set the REC TYPE parameter to “OVERDUB.”
5 Press the PLAY p button to begin recording. You
don’t actually need to record any new data; the grid
groove setting will automatically be recorded.
6 Press the STOP s button to stop recording after
the pattern has played through once. The Grid Groove
settings will automatically be initialized when record-
ing is stopped.
3. Groove
To Next Page
Loading...
