RM1x SEQUENCE REMIXER 67
PATTERN MODE
❏ LFO
The RM1x LFO (Low Frequency Oscillator) can be used to modulate pitch, filter cutoff frequency, or amplitude to create a
wide range of modulation effects.
Track number
Transpose
8. Voice Edit
Parameter Values Function
LFO rate -64 ... 00 ... +63 Sets the speed of the LFO.
Higher values produce faster LFO variation.
Pitch depth 000 ... 127 Sets the depth of LFO pitch modulation.
Periodic pitch modulation produces a vibrato-type effect. This pa-
rameter determines how deeply the LFO modulates pitch, and thus
the depth of the resultant vibrato.
Filter depth 000 ... 127 Sets the depth of LFO filter modulation.
Periodic filter cutoff frequency modulation produces a wah-wah pedal
type effect. This parameter determines how deeply the LFO modu-
lates filter cutoff frequency, and thus the depth of the resultant ef-
fect.
Amp. depth 000 ... 127 Sets the depth of LFO amplitude modulation.
Periodic amplitude modulation produces a tremolo effect. This pa-
rameter determines how deeply the LFO modulates amplitude, and
thus the depth of the resultant tremolo.
Track number 01 ... 16 Shows the current selected track number. Track number selection
can be accomplished via this parameter, or by the keyboard method
described on page 27.
Transpose -36 ... 0 ... +36 Shows the current transpose value. Transposition can be accom-
plished via this parameter, or by the keyboard method described on
page 27.
* For information about how to change values, refer to the Basic Operation (page26).
To Next Page
Loading...
