RM1x SEQUENCE REMIXER 91
PATTERN MODE
Job 14 Create Continuous Data
1
3
2
4
5
6
7
8
Creates continuous control change data over the range of the
specified segment. This can be useful for inserting precise
pitch bends and other control variations.
1. Phrase setting: Phrs
Sets the phrase to which adjustment is applied.
■ Settings : 001 ... 256
2. Segment (M001:1:000 ~ M257: 1:000)
Sets the area of the phrase over which adjustment is
carried out. The first segment sets the measure, beat,
and clock for the start point; the second segment sets
the end point.
■ Settings : Measure: beat : clock
001:1:000 ... 999:8:479
3. Event Type
Selects the event type to be created (at the center of the
screen).
■ Settings : PB (Pitch bend), CC (Control
change), CAT (Channel aftertouch),
EXC (System exclusive)
4. Control Change No.
When “CC” is selected the cursor can be moved to the
control change number to specify the type of the con-
trol change data to be created.
■ Settings : 000 ... 127
5. Times
This multiplier specifies the number of times the data
created within the specified segment is to be repeated.
■ Settings : 01 ... 99
6. Data
Specifies the lower and upper limits for the data to be
created. The left value is the low limit, and the right
value is the upper limit.
■ Settings : 000 ... 127, -8192 ... +8191 (Event
Type=PB)
7. Clock
Specifies the number of clocks between each created
event to be inserted.
■ Settings : 001 ... 999
8. Curve
Specifies the degree of positive or negative “curvature”
that will be applied to the continuous data. “+00” pro-
duces a linear curve. Positive values create an increas-
ingly positive curve (i.e. upward curve). and negative
values produce an increasingly negative curve (i.e.
downward curve).
■ Settings : -16 ... +16
Job 15 Thin Out
1
3
2
You use this job to remove some occurrences of a specified
non-note event within the designated segment of a selected
track. The purpose is to reduce the data volume and free up
additional memory.
Specifically, the job will remove every other occurrence of
the event in areas where the event recurs within 60 clock cy-
cles. The job will not remove an event that is separated from
the previous occurrence by at least 60 clock cycles.
1. Phrase setting: Phrs
Selects the target phrase.
■ Settings : 001 ... 256
2. Segment (M001:1:000 ~ M257: 1:000)
Sets the area of the phrase to be thinned. The first seg-
ment sets the measure, beat, and clock for the start point;
the second segment sets the end point.
■ Settings : Measure: beat : clock
001:1:000 ... 257:1:000
3. Event type
Selects the targeted event type.
■ Settings : PB (Pitch bend), CC (Any single Con-
trol Change message type, 000 to
127), CAT (Channel aftertouch), PAT
(Polyphonic aftertouch)
12. Job
To Next Page
Loading...
Need help?
General
