3 En
NAMES OF PARTS AND THEIR FUNCTIONS
1 Illumination sensor
Detect ambient lighting. Do not cover this sensor
(☞ P. 6).
2 Alarm time
Indicates the alarm time (☞ P. 19).
3 Repeat/shuffle indicator
Displays the playback mode (☞ P. 9).
4 Secondary indicator
Turns on if a secondary station is playing when you
listen to a DAB station.
5 Multi-function indicator
Displays various information, including the clock time,
information about the currently-playing track, and the
frequency of the radio station.
6 Remote control signal receiver
Make sure that this sensor is not obstructed (☞ P. 1).
7 Weekly alarm indicator
Shows alarm information specified using the free “DTA
CONTROLLER” application for a smartphone and
tablet computer (☞ P. 21).
8 Alarm indicator
Turns on if the alarm has been set (☞ P. 20).
9 Sleep indicator
Turns on if the sleep timer has been set (☞ P. 21).
1 CLOCK switch
Sets the clock and specifies whether the clock will be
displayed (☞ P. 5).
2 AUX
Use a commercially available 3.5 mm mini-plug cable
to connect your external device here (☞ P. 9).
3 DAB/FM antenna connector
Connect the DAB/FM antenna here.
• If reception is poor, try changing the height or direction of the
antenna, or move the unit to find a location that has better
reception.
• If you use a commercially available outdoor antenna instead of
the supplied antenna, reception may be better.
Front panel display
~~~~~~
~~~~~~
65
7
21
8 9
3 4
Rear panel
1 2 3
SET:
Set the clock.
ON:
Even when the unit is off, the clock will be
displayed and the alarm function will be available.
OFF:
When the unit is off, the clock will not be displayed
and the alarm function will not be available
.
Be sure to stretch out the antenna.
TSX-B235_AB_En.book Page 3 Wednesday, May 13, 2015 5:27 PM
To Next Page
Loading...
Need help?
General
