62
11. Accessory
List of accessories
Show the list of optional accessories for this Equipment on Tables11.1 and 11.2.1
Muffle Furnace (FP series) support a wide variety of optional parts.
※Note that some optional parts may not be installed after delivery.
Table 11.1 List of Options (installation possible after delivery)
Tray to place heated specimens.
Place specimens on this plate put
on the bottom in the furnace.
(145 × 90 × 6mm) (5 plates
included)
Place specimens on this plate put
on the bottom in the furnace.
(245 × 190 × 8mm) (5 plates
included)
Place specimens on this plate put
on the bottom in the furnace.
(290 × 245 × 8mm) (5 plates
included)
Table 11.2 List of options (installation not possible after delivery)
Temperature output
terminal
Terminal to output 4-20mA
analogue signals of the
temperature sensor of the unit to
the externals.
External Alarm Output
Terminal
Output alarm signal at occurring
error on this Equipment.
Display its particular error on
Bottom Screen.
External
communication
terminal (RS485
Monitor operation state of this
Equipment and control it remotely。
External
Communication
Adaptor Set
Connect this Equipment with PC
through this adaptor for external
communication.
（Application software attached to
this Set.）
Terminal to output to the externals
while END is displayed at
automatic stop and the end of the
programmed operation.
Operation signal
output terminal
Terminal to output to the externals
while the unit is operating.
Terminal to output the ON-OFF
signal to the externals set in
different states (standby, operation,
end or steps).
To Next Page
