4. Disassembly and Reassembly
92
(38) Filling with lube oil
Fill the engine with lube oil from the supply port on top of the gear case and fill the marine gearbox from
the supply port on top of the clutch case.
(39) Filling with cooling water
1) Open the coolant (fresh water) tank cap and fill with water.
2) Fill with water until the level in the coolant recovery tank is between the full and low marks.
(40) Check fuel injection timing
Refer to 2.2.5(1) in chapter 2.
(41) Test Running
Refer to “Adjusting operation” of 2.4 in chapter 2.
(L)
Engine capacity 4.5
(L)
Coolant recovery tank capacity (full) 0.8
To Next Page
