Yanmar 3TNV88F - Page 237

ALTERNATOR
3TNV88F Service Manual
11-19
Dynamo
Disassembly of Dynamo
1. Remove the rear cover (Figure 11-24, (1)).
2. Remove the nut (Figure 11-24, (2)), lock
washer (Figure 11-24, (3)), and flat washer
(Figure 11-24, (4)).
Figure 11-24
3. Remove the through bolt (Figure 11-25, (1)),
pulley half (Figure 11-25, (2)), flywheel
(Figure 11-25, (3)), flat washer
(Figure 11-25, (4)), bearings
(Figure 11-25, (5)), and spacer
(Figure 11-25, (6)).
Figure 11-25
4. Remove the screws (Figure 11-26, (1)) and the
stator assembly (Figure 11-26, (2)).
5. Remove the rear bearing (Figure 11-26, (3)).
Figure 11-26
Reassembly of Dynamo
1. Reinstall the rear bearing (Figure 11-27, (3)).
2. Reinstall the stator (Figure 11-27, (2)) and
screws.
Figure 11-27
K0002143X
1
2
3
4
K0002144X
6
5
4
3
2
1
K0002145X
3
2
1
K0002145X
3
2
1
3TNV88F_SVM_A4.book 19 ページ ２０１２年７月２６日 木曜日 午後６時４分