Yanmar 4LHA-DTP - (B) Working Wear; (C) Tools to be Used; (D) Use of Genuine Parts, Oil and Grease; (E) Bolt and Nut Tightening Torques

Chapter 0 For Safety
2. Precaution For Safe Servicing
i 4LHA Seriei
(B) Working Wear
A-CAUTiaM
Tight-fitting^
Ok"
•Wears for safe operation
Wear a helmet, working clothes, safety shoes and other safety protectors
suited to the job. It is especially important to wear well-fitting work clothes.
[Failure to Observe]
A serious accident such as trapping by a machine may occur.
(C) Tools to be Used
AWARNING
• Appropriate holding and lifting
Never operate when the engine is supported with blocks or wooden pieces
or only with a jack.
To lift and hold the engine, always use a crane with a sufficient allowance in
limit load or a rigid jack.
[Failure to Observe]
A serious accident may occur.
AWARNING
• Use of appropriate tools
Use tools appropriate for the jobs to be done. Use a correctly sized
tool for loosening or tightening a machine part.
[Failure to Observe]
A serious injury or engine damage may occur.
(D) Use of Genuine Parts, Oil and Grease
AXAUTION
• Always use genuine parts.
[Failure to Observe]
Shortening of engine life or an unexpected accicdent may arise,
v
(E) Bolt and Nut Tightening Torque
AWARNING
• Always tighten to the specified torque if designated
in the manual.
[Failure to Observe]
Loosening or falling may cause parts damage or injury.
0-3