Yanmar CANplus 600 - Page 32

Yanmar
®
600 Control Panel Operation and Troubleshooting
32 463-3000-09 Initial - 16-May-2008
Icon Parameter Gauge Pages Single Gauge Database
Intake Manifold Temperature   
Air Inlet Temperature
  
Exhaust Temperature
  
Auxiliary Temperature 1   
Engine ECU Temperature

Exhaust Gas Port 1 Temperature
 
Exhaust Gas Port 2 Temperature
 
Turbo Inlet Temperature  
Percentage (%)
Acceleration Position
 
Engine Oil Level   
Coolant Level
  
Fan Speed
 
Drivers Demand Percent Torque
 
Actual Engine Percent Torque
  
Percent Load at RPM
  
Speed (RPM, km/h, MPH or KTS)
Input Shaft Speed
 
Output Shaft Speed
 
Engine Speed
  
Turbo 1 Speed  
Engine Desired Operating Speed
 
Fan Speed  
Vehicle Speed
  
Time (h)
Total Engine Hours  
Trip Engine Hours
 
Service Hours

Miscellaneous
Torque Converter Lock-Up Engaged

Current Gear
 
Selected Gear
 
CANTX Disable

Abbreviations
The units MPG and Gal denote US gallons. For non-US US gallons (UK, Canada, etc) the units are denoted
as IMPG or IGal. N denotes nautical miles. KTS denotes knots.
Note
If a parameter is not transmitted on the CANbus it will not be possible to select it.
If a configured gauge parameter is unavailable, is displayed.