YARDMAX YS2565 - Log Stripper, Tow Bar, and Wheel Setup

Trunnion Mount
M10x20 (x1)
M10x20 (x1)
M10x35 (x2)
M10x35 (x2)
Log Stripper
LOG STRIPPER (YS2565, YS2865, and YS3065 ONLY)
LOG STRIPPER (YS3567 ONLY)
1. Align holes in the log stripper with the holes in the trunnion
mount.
2. Install the log stripper by tightening the M10x35 bolts, spring
washers, and at washers. (See Figure 5a)
1. Align holes in the log stripper with the holes in the trunnion
mount.
2. Install the log stripper by tightening the M10x35 and M10x20
bolts, spring washers, and at washers. (See Figure 5b)
M10x35 (x3)
M10x35 (x3)
Log Stripper
Trunnion Mount
TOW BAR
Insert the tow bar into the tank bracket and align the holes.
Connect and tighten the tow bar to the tank by using the M12x80
bolts, at washers, spring washers, and nuts. (See Figure 6)
WHEEL
2. Remove the anti-dust sleeves from the two wheels. Take the
anti-dust washers and roller bearings from the wheels and set
aside for later use.
1. Remove the two anti-dust sleeves from the wheel axle.
Anti-dust Sleeve (x2)
Wheel Axle
M10 X 35 X 6
2
YS2565
YS2865
YS3065
M12 X 80 X 2
3
16 mm
13 mm
18 mm
19 mm
X 2
32 mm
13 mm
16 mm
19 mm
M10 X 35 X 4
2
YS3567
M10 X 20 X 2
32 mm
13 mm
16 mm
19 mm
Anti-dust Washer (x2)
Anti-dust Sleeve (x4)
Roller Bearing (x4)
M12x80 (x2)
Tank Assembly
Bracket
Tow Bar
Assembly
YS2565PM01 - 1609
13
|
Assembly
Figure 5b
Figure 5a
Figure 7b
Figure 7a
Figure 6
65876US25M101.indd 13 2016/8/26 11:10:32