1 Safety Information
1.4 Motoman Safety
18
165841-1CD
R-AN-A307
DX200 Notes for Safe
Operation
• Perform the following inspection procedures prior to teaching the
manipulator. If problems are found, correct them immediately, and
be sure that all other necessary tasks have been performed.
– Check for problems in manipulator movement.
– Check for damage to the insulation and sheathing of external
wires.
• Always return the programming pendant to its hook on the DX200
cabinet after use.
If the programming pendant is inadvertently left on the manipulator, a
fixture, or on the floor, the manipulator or a tool could collide with it
during manipulator movement, possibly causing injury or equipment
damage.
To Next Page
Loading...
