Need help?Do you have a question about the YASKAWA E7 Drive and is the answer not in the manual?
General| Series | E7 |
|---|---|
| Frequency | 50/60 Hz |
| Output Voltage | Matches Input Voltage |
| Horsepower Range | 0.5 HP to 300 HP |
| Power Range | 0.4 kW to 220 kW |
| Control Method | V/f control |
| Overload Capacity | 150% for 60 seconds |
| Protection Functions | Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault |
| Communication Options | Modbus RTU, DeviceNet, Ethernet/IP |
| Operating Temperature | -10°C to 50°C |
| Storage Temperature | -20°C to +60°C (-4°F to 140°F) |
| Humidity | 5% to 95% (non-condensing) |
| Cooling Method | Fan Cooled |
| Enclosure Rating | IP20 |
| Dimensions | Varies by model (refer to datasheet) |
Details specifications for wire sizes and connectors for main circuit terminals.
Checklist for preparing the drive before initial start-up.
Step-by-step procedures for energizing and configuring the drive.
Configures the input source for the speed command signal.
Sets the nominal input voltage for drive protective features and base voltage.
Configures the motor's full load amps for protection and auto-tuning.
Details the Proportional-Integral control capabilities and configuration.
Procedure for performing motor auto-tuning for optimal performance.
Information on fault displays, causes, and corrective actions.
Details alarm displays, causes, and corrective actions.
Guidance for resolving operational issues due to settings or wiring.
To Next Page