To Next PageTo Next Page
Need help?Do you have a question about the YASKAWA E1000 and is the answer not in the manual?
General| Brand | YASKAWA |
|---|---|
| Model | E1000 |
| Category | Controller |
| Language | English |
Detailed safety precautions, including hazard warnings (DANGER, WARNING, CAUTION, NOTICE) and general handling guidelines.
Detailed procedures for proper mounting, installation environment, orientation, and spacing.
Illustrates the standard wiring for connecting the drive and peripheral devices.
Describes procedures for safely wiring the main circuit terminals and motor terminals.
Explains the wiring procedures for the control circuit terminals, including digital and analog inputs/outputs.
Explains the functions of the digital operator's keys and displays for entering commands and parameters.
Describes the two main modes of operation: Drive Mode and Programming Mode.
Explains different types of auto-tuning for induction and permanent magnet motors and the data required.
Parameters related to acceleration, deceleration, S-curves, torque compensation, and carrier frequency.
Parameters for configuring V/f patterns and motor data, including induction and PM motor settings.
Parameters for drive and motor protection, including overload, overheat, stall, and undervoltage protection.
Descriptions of drive faults, alarms, errors, related displays, and guidance for troubleshooting.
Detailed displays, causes, and possible solutions for various drive faults.
Describes operator programming errors (oPE codes), their causes, and solutions.
Procedure for removing fault triggers and restarting the drive.
Addresses common problems that do not trip an alarm or fault, such as motor hunting or incorrect parameter settings.
Information on component wear, predicted maintenance periods, and replacement parts.
Provides instructions on installing option cards, including prior steps and component views.
Describes proper steps and precautions for installing peripheral devices like braking units and MCCBs.
Summary of drive specifications, including control characteristics, protection functions, and environmental requirements.
A comprehensive listing of all drive parameters, their addresses, descriptions, settings, and page references.
Explains how to configure drives for MEMOBUS/Modbus communication using master/slave setup.
Explains how to connect the drive to a MEMOBUS/Modbus network and the required network termination.
Lists MEMOBUS/Modbus error codes, their causes, and possible solutions for communication issues.
