B.1 Understanding the Parameter Table
358 YASKAWA ELECTRIC SIEP C710616 35D YASKAWA AC Drive E1000 Technical Manual
B.1 Understanding the Parameter Table
◆ Control Modes, Symbols, and Terms
The table below lists terms and symbols used in this section to indicate which parameters are available in which control
modes.
Note: For detailed instructions on each control mode, Refer to Control Mode Selection on page 28.
Table B.1 Symbols and Icons Used in the Parameter Table
Note: If a parameter is not available in a certain control mode, the symbol for that control mode is grayed out.
Symbol Description
Indicates the parameter is accessible in all control modes.
Parameter is available when operating the drive with V/f Control.
Parameter is available when operating the drive with Open Loop Vector for PM motors.
Indicates this parameter can be changed during run.
All Modes
V/f
OLV/PM
SIEP_C710616_35.book 358 ページ ２０１５年１１月３０日 月曜日 午後２時２分
To Next Page
Loading...
