C.1 MEMOBUS/Modbus Configuration
412 YASKAWA ELECTRIC SIEP C710616 35D YASKAWA AC Drive E1000 Technical Manual
C.1 MEMOBUS/Modbus Configuration
Drives can be controlled from a PLC or other master device via serial communications using the MEMOBUS/Modbus
protocol.
MEMOBUS/Modbus communication can be configured using one master (PLC) and a maximum of 255 slaves. The
drive has slave functionality only, meaning that serial communication is normally initiated from the master and
responded to by the slaves.
The master performs serial communications with only one slave at a time. The address or node for each slave must be set
beforehand so that the master can communicate with the slave at that address. A slave that receives a command from the
master will perform the specified function and then send a response back to the master.
Figure C.1
Figure C.1 Connecting Multiple Drives to a PLC
Master (PLC or other)
Sl av e (Dri ve)
SIEP_C710616_35.book 412 ページ ２０１５年１１月３０日 月曜日 午後２時２分
To Next Page
Loading...
