4.2 Using the Digital Operator
100 YASKAWA ELECTRIC SIEP C710616 35D YASKAWA AC Drive E1000 Technical Manual
◆ Menu Structure for Digital Operator
Figure 4.4
Figure 4.4 Digital Operator Menu and Screen Structure
<1> Reverse can only be selected when the drive is set for LOCAL. Details on switching between forward and reverse can be found in
Navigating the Drive and Programming Modes on page 101.
XXXX
XX
XX
XX
XX
XX
XX
XX
XX
XX
XX
<1>
XX
XX
X
ALM
DIGITAL OPERATOR JVOP-182
REV DRV FOUT
DRV
XXX
XX
XX
XX
X
XX
X
XX
XX
Note: “XX” characters are shown in this manual.
The drive will display the actual setting values.
Pressing RUN will start the motor.
DRIVE MODE
DRV light is on.
Drive cannot operate the motor.
PROGRAMMING MODE
DRV light is on.
Turn the power on
Forward Selection
Output Frequency
Output Current
Output Voltage
Monitor Display
Verify Menu
Set Up Mode
Parameter Setting Mode
Auto-Tuning
Reverse Selection
Description of Key Operations
SIEP_C710616_35.book 100 ページ ２０１５年１１月３０日 月曜日 午後２時２分
To Next Page
Loading...
Need help?
General
