YASKAWA E7 Drive - Basic Programming

Basic Programming 5 - 1
Chapter 5
Basic Programming
This chapter describes basic programming for the Drive.
Basic Programming Parameters..........................................5-2
Language Selection.............................................................5-2
Speed Command Source Selection.....................................5-2
Run Command Source Selection ........................................5-3
Stopping Method Selection..................................................5-5
Reverse Operation Selection...............................................5-6
Drive Delay..........................................................................5-7
PI Function ..........................................................................5-8
Energy Savings .................................................................5-14
Accel/Decel Time Settings.................................................5-14
Speed Command Limits ....................................................5-15
Input Voltage Setting .........................................................5-15
Motor Rated Current Setting..............................................5-16
Option Communication Error Selection .............................5-16
Gain and Bias Adjustment .................................................5-16
Momentary Power Loss Function ......................................5-17
Speed Command Loss Detection ......................................5-18
Auto Restart.......................................................................5-18
Torque Detection ...............................................................5-19
Cooling Fan Operation ......................................................5-21
Monitor Configuration ........................................................5-21
User Initialization ...............................................................5-22
Speed Command Setting Selection...................................5-22
Elapsed Timer Function.....................................................5-23
Digital Operator COPY Function........................................5-23
Auto-Tuning .......................................................................5-26