vii
Storage and Transportation
• Connect the ground terminal according to local electrical codes (100 Ω or
less).
Improper grounding may result in electric shock or fire.
• Installation, disassembly, or repair must be performed only by authorized
personnel.
Failure to observe this warning may result in electric shock or injury.
WARNING
CAUTION
• Do not store or install the product in the following locations.
Failure to observe this caution may result in fire, electric shock, or damage to the
equipment.
• Locations subject to direct sunlight
• Locations subject to temperatures outside the range specified in the storage/
installation temperature conditions
• Locations subject to humidity outside the range specified in the storage/instal-
lation humidity conditions
• Locations subject to condensation as the result of extreme changes in tempera-
ture
• Locations subject to corrosive or flammable gases
• Locations subject to dust, salts, or iron dust
• Locations subject to exposure to water, oil, or chemicals
• Locations subject to shock or vibration
• Do not hold the product by the cables, motor shaft, or encoder while trans-
porting it.
Failure to observe this caution may result in injury or malfunction.
• Do not place any load exceeding the limit specified on the packing box.
Failure to observe this caution may result in injury or malfunction.
• If disinfectants or insecticides must be used to treat packing materials such
as wooden frames, pallets, or plywood, the packing materials must be
treated before the product is packaged, and methods other than fumigation
must be used.
Example: Heat treatment, where materials are kiln-dried to a core
temperature of 56°C for 30 minutes or more.
If the electronic products, which include stand-alone products and products
installed in machines, are packed with fumigated wooden materials, the electrical
components may be greatly damaged by the gases or fumes resulting from the
fumigation process. In particular, disinfectants containing halogen, which includes
chlorine, fluorine, bromine, or iodine can contribute to the erosion of the capaci-
tors.
To Next Page
Loading...
Need help?
General
