YASKAWA GA800

4 Maintenance
YASKAWA TOEPC71061779D GA800 Drive Installation Manual 29
3. Install the drive in the cut opening of the enclosure panel and use screws to safety it to the enclosure panel.
Tighten the screws to a correct tightening torque:
• M5 screws: 1.96 N∙m to 2.53 N∙m (17.35 lbf∙in to 22.39 lbf∙in)
• M12 screws: 31.38 N∙m to 39.23 N∙m (34.70 in∙lb to 43.37 in∙lb)
A - Enclosure panel
B - Gaskets
C - M12 screws
D - M5 screws
Figure 3.27 Install the Drive into the Opening of the Enclosure Panel
◆ Gasket Models
Table 3.5 Gasket Models
Drive Model Gasket (Vertical Side) Gasket (Horizontal)
2004 - 2042
4002 - 4023
400-098-548-002 400-098-548-001
2056
4031, 4038
400-098-548-004 400-098-548-003
2070, 2082
4044, 4060
400-098-548-006 400-098-548-005
2110
4075
400-105-823-002 400-105-823-001
2138
4089, 4103
T103
400-098-548-008 400-098-548-007
2169, 2211
4140, 4168
T140, T168
400-098-548-010 400-098-548-009
2257, 2313
4208 - 4302
T208 - T302
400-098-548-012 400-098-548-011
2360, 2415
4371, 4414
5289
T371, T414
400-098-548-014 400-098-548-013
4477 - 4720
5382 - 5472
T477 - T720
400-098-548-016 400-098-548-015
4 Maintenance
Refer to the Maintenance & Troubleshooting Manual (TOEPYAIGA8001) for more information.
Only let authorized persons do maintenance, examine, or replace components on the drive.