4 Maintenance
54 YASKAWA TOEPC71061779D GA800 Drive Installation Manual
A - Screw position A
B - Screw position B
C - Fan unit
Figure 4.57 Slide the Fan Unit
6. Connect the fan cable to the fan connectors.
A - Fan unit
B - Fan connectors
C - Fan cable
Figure 4.58 Connect Cooling Fan Connectors
7. Install the drive cover.
8. Energize the drive and set o4-03 = 0 [Fan Operation Time Setting = 0 h] to reset the fan operation time.
Circuit Board Cooling Fan Removal
Remove the drive cover before you start this procedure.
CAUTION
Crush Hazard. Loosen the cover screws. Do not fully remove them. If you fully remove the cover screws, the
terminal cover can fall and cause moderate injury.
To Next Page
Loading...
