YASKAWA GPD 315/V7 - Page 32

GPD315/V7 Modbus RTU Technical Manual TM 4325
Page
28
Table 5-4 Drive Parameters (continued)
Parameter ADDR Name Set
Description
Default
n090 015Ah
DC Injection
Time @ Stop
0.0 - 25.5 Seconds (0.0 = Disabled) 0.5
n091 015Bh
DC Injection
Time @ Start
0.0 - 25.5 Seconds (0.0 = Disabled) 0.0
0 Enabled
n092 015Ch
Stall Prevention
During Decel
1 Disabled
0
n093 015Dh
Stall Prevention
During Accel
30 - 200% (200% = Disabled 170
n094 015Eh
Stall Prevention
During Run
30 - 200% (200% = Disabled) 160
n095 015Fh
Frequency
Detection Level
0.00 - 9.99hz or 100.0 - 400.0hz 0.00
0 Detection Disabled.
1 Detects Only @ Speed Agree; Operation Continues
2 Detects Only @ Speed Agree; Coast To Stop
3 Detects During Run; Operation Continues
n096 0160h
Overtorque
Detection 1
4 Detects During Run; Coast To Stop
0
0 Detected By Output Torque
n097 0161h
Overtorque
Detection 2
1 Detected By Output Current
0
n098 0162h
Overtorque
Detection Level
30 - 200% 160
n099 0163h
Overtorque
Detection Time
0.1 - 10.0 Seconds 0.1
0 Output Frequency is Not stored when using up/down function
n100 0164h
Up/Down
Memory Hold
1 Output Frequency is stored when using up/down function
0
n101 0165h Reserved
3
n102 0166h Reserved
3
n103 0167h
Torque
Compensation
Gain
0.0 - 2.5 1.0
n104 0168h
Torque
Compensation
Time Constant
0.0 - o 25.5 Seconds (0 Disables Primary Delay Filter) 0.3
n105 0169h
Torque
Compensation
Iron Loss
0.0 – 999.9W or 1000 – 6550W
6
n106 016Ah
Motor Rated
Slip
0.0 - 20.0hz
6
n107 016Bh
Motor Line-To-
Line
Resistance
0.000 – 9.999ω or 10.00 – 65.50ω
6
n108 016Ch
Motor Leakage
Inductance
0.00 – 99.99mh or 100.0 - 655.0mh
6
n109 016Dh Torque Limiter 0 - 250% (Vector Control Mode) 150
n110 016Eh
Motor No-Load
Current
0 - 99%
6
n111 016Fh
Slip
Compensation
Gain
0.0 - 2.5 0.0
n112 0170h
Slip
Compensation
Time Constant
0.0 - 25.5 Seconds (0.0 Disables Primary Delay Filter) 2.0
0 Disabled
n113 0171h
Slip
Compensation
During Regen
1 Enabled
0
n114 0172h Reserved
3
0 Disabled (Level Based On N094)
n115
4
0173h
Stall Prevention
During Run
1 Enabled (Level At FMAX Is N094 X 0.4)
0