4 Keypad: Names and Functions
10 YASKAWA TOEP C730600 97C LCD Keypad Installation Manual
Table 4.1 Keypad: Names and Functions
- Name Function
A
RUN LED
Illuminates to show that the drive is operating the motor.
The LED turns OFF when the drive stops.
Flashes to show that:
• The drive is decelerating to stop.
• The drive received a Run command with a frequency
reference of 0 Hz, but the drive is not set for zero speed
control.
Flashes quickly to show that:
• The drive received a Run command from the MFDI terminals
and is switching to REMOTE Mode while the drive is in
LOCAL Mode.
• The drive received a Run command from the MFDI terminals
when the drive is not in Drive Mode.
• The drive received a Fast Stop command.
• The safety function shut off the drive output.
• You pushed on the keypad while the drive is
operating in REMOTE Mode.
• The drive is energized with an active Run command and b1-
17 = 0 [Run Command at Power Up = Disregard Existing
RUN Command].
B
ALM LED
Illuminates when the drive detects a fault.
Flashes when the drive detects:
• An alarm
• An oPE parameter setting error
• A fault or alarm during Auto-Tuning
The light turns off during regular drive operation. There are no
alarms or faults.
C
microSD
Card
Insertion
Slot
The insertion point for a microSD card.
To Next Page
Loading...