4 Keypad: Names and Functions
YASKAWA TOEP C730600 97C LCD Keypad Installation Manual 11
- Name Function
D
Function
Keys
F1, F2, F3
The menu shown on the keypad sets the functions for function
keys.
The name of each function is in the lower half of the display
window.
E
LO/RE LED
Illuminated: The keypad controls the Run command (LOCAL
Mode).
OFF: The control circuit terminal or serial transmission device
controls the Run command (REMOTE Mode).
Note:
• LOCAL: Use the keypad to operate the drive. Use the
keypad to enter Run/Stop commands and the frequency
reference command.
• REMOTE: Use the control circuit terminals or serial
transmission to operate the drive. Use the frequency
reference source in b1-01 and the Run command source in
b1-02.
F
LO/RE
Selection
Key
Switches drive control for the Run command and frequency
reference between the keypad (LOCAL) and an external source
(REMOTE).
Note:
• The LOCAL/REMOTE Selection Key continuously stays
enabled after the drive stops in Drive Mode. If the
application must not switch from REMOTE to LOCAL
because it will have a negative effect on system
performance, set o2-01 = 0 [LO/RE Key Function Selection
= Disabled] to disable .
• If the drive is receiving a Run command from an external
source, it will not switch between LOCAL and REMOTE.
G
STOP Key
Stops drive operation.
Note:
Push to stop the motor. This will also apply when a
Run command (REMOTE Mode) is active at an external
Run command source. Set o2-02 = 0 [STOP Key Function
Selection = Disabled] to disable in REMOTE
Mode.
To Next Page
Loading...