What to do if YASKAWA PG-X3 Controller displays 'Option Connection Error at drive port CN5-C'?
If your YASKAWA Controller is showing an 'Option Connection Error at drive port CN5-C', it means the option at drive port CN5-C was changed during run. To fix this, switch the power off and reconnect the option.
Why YASKAWA PG-X3 detects Inversion?
Inversion detection on your YASKAWA Controller can occur due to several reasons: * The Z channel pulse offset is not set properly to E5-11: Set the value for ?? to E5-11 as specified on the motor nameplate. Replacing the PG encoder or changing the application so the motor rotates in reverse requires readjustment of the Z channel pulse offset. * An external force on the load side caused the motor to move: * Make sure the motor is rotating in the proper direction. * Investigate problems on the load side causing motor rotation in the opposite direction. * Noise interference along the PG cable affecting the A channel or B channel: * Rewire the PG encoder and make sure all wiring including shielded wiring is properly connected. * If the problem continues after cyc...
Lists available manuals for the option and drive.
Explains safety message conventions (DANGER, WARNING, CAUTION).
Provides general safety precautions for using the manual and equipment.
Describes the PG-X3 Option's functionality and benefits.
Lists drive models compatible with the PG-X3 option.
Lists items included in the option package and required installation tools.
Details the components and connections of the PG-X3 option.
Shows terminal block layouts and their functions.
Provides critical safety warnings related to electrical shock during installation.
Covers warnings about wiring, fire hazards, and equipment damage.
Explains preparation steps before installing the option.
Details shutting off power and removing covers for installation.
Describes inserting the option and connecting ground wires.
Explains how to route option wiring, with examples.
Covers preparing wire ends and connecting terminals.
Details wiring the PG encoder and setting initial parameters.
Shows connection diagram and parameter settings for different encoder types.
Explains setting PG power supply voltage using jumper CN3.
Describes replacing front covers and the digital operator.
Details setting drive parameters for motor rotation direction.
Lists specifications for wire gauges, torque, and crimp terminals.
Steps to prevent erroneous operation due to noise.
Diagram showing the PG-X3 interface circuit.
Lists fault displays, causes, and solutions for drive errors.
Details specific fault codes like dv3, dv4 and their solutions.
Details fault codes like OFA00, OFb00, OFb01, OFc01, OPE06, OS.
Details fault codes like PGo, PGOH and their solutions.
Lists revision dates and changes made to the manual.
General| Brand | YASKAWA |
|---|---|
| Model | PG-X3 |
| Category | Controller |
| Language | English |
To Next Page