7.4 Jog Speed Table Operation
7.4.4 SigmaWin+ Procedures
7-47
7
Operation with Digital I/O
Writing the Jog Speed Table
You can write the edited jog speed table to SERVOPACK RAM to operate the SERVOPACK
according to the program.
1.
Click the Write Button on the Jog Speed Table Editing Dialog Box.
The Write Dialog Box will be displayed.
2.
Click the OK Button.
The jog speed table edited on the SigmaWin+ will be written to the SERVOPACK and the edited cells
will change to white.
Comment Button Lets you add a comment.
Import Button Imports a jog speed table from a file saved on the computer to the SigmaWin+.
Initialize Button Initializes the flash memory in the SERVOPACK.
Save Button Saves the settings in the SERVOPACK to flash memory.
Read Button Reads the settings in the SERVOPACK to the SigmaWin+.
Write Button Writes the currently displayed settings to the SERVOPACK.
1. Make sure that the system is in SERVO OFF state when you write the jog speed table.
2. The jog speed table that is written will be deleted when the power supply to the SERVOPACK is
turned OFF. Before you turn OFF the power supply to the SERVOPACK, save the jog speed table
from RAM to flash memory. Refer to the following section for the operating procedure.
Saving the Jog Speed Table on page 7-48
Continued from previous page.
No. Item Description
To Next Page
Loading...
