YASKAWA SGD7S-180A

10.1 Corresponding SERVOPACK and SigmaWin+ Function Names
10.1.2 Corresponding SERVOPACK Monitor Display Function Names
10-3
10
Appendices
10.1.2 Corresponding SERVOPACK Monitor Display Function
Names
Alarms
Alarm Display
Fn000 Display Alarm History
Fn006 Clear Alarm History
Reset Motor Type Alarm Fn021 Reset Motor Type Alarm
Solutions Mechanical Analysis – –
Tab le
Editing
Edit Program Table
Fn060 Edit/Save Program Table
Fn063 Initialize Program Table
Edit ZONE Table
Fn061 Edit/Save ZONE Table
Fn064 Initialize ZONE Table
Edit Jog Speed Table
Fn062 Edit/Save Jog Speed Table
Fn065 Initialize Jog Speed Table
Continued from previous page.
SigmaWin+ SERVOPACK
Menu Bar
Button
Function Name Fn No. Function Name
SigmaWin+ SERVOPACK
Menu Bar
Button
Name [Unit] Un No. Name [Unit]
Motion
Monitor
Motor Speed [min
-1
]
Un000
Motor Speed [min
-1
]
Speed Reference [min
-1
]
Un001
Speed Reference [min
-1
]
Torque Reference [%] Un002
Torque Reference [%]
(percentage of rated torque)
• Rotary Servomotors:
Rotational Angle 1 [encoder
pulses]
(number of encoder pulses from
origin within one encoder rotation)
• Linear Servomotors:
Electrical Angle 1 [linear encoder
pulses]
(linear encoder pulses from the
polarity origin)
Un003
• Rotary Servomotors:
Rotational Angle 1 [encoder pulses]
(number of encoder pulses from origin within
one encoder rotation displayed in decimal)
• Linear Servomotors:
Electrical Angle 1 [linear encoder pulses]
(linear encoder pulses from the polarity origin
displayed in decimal)
• Rotary Servomotors:
Rotational Angle 2 [deg]
(electrical angle from origin within
one encoder rotation)
• Linear Servomotors:
Electrical Angle 2 [deg]
(electrical angle from polarity ori-
gin)
Un004
• Rotary Servomotors:
Rotational Angle 2 [deg]
(electrical angle from polarity origin)
• Linear Servomotors:
Electrical Angle 2 [deg]
(electrical angle from polarity origin)
Input Reference Pulse Speed [min
-1
]
Un007
Input Reference Pulse Speed [min
-1
]
(displayed only during position control)
Position Deviation [reference units] Un008
Position Error Amount [reference units]
(displayed only during position control)
Accumulated Load Ratio [%] Un009
Accumulated Load Ratio [%]
(percentage of rated torque: effective torque in
cycles of 10 seconds)
Regenerative Load Ratio [%] Un00A
Regenerative Load Ratio [%]
(percentage of processable regenerative
power: regenerative power consumption in
cycles of 10 seconds)
Dynamic Brake Resistor Power Con-
sumption [%]
Un00B
Power Consumed by DB Resistance [%]
(percentage of processable power at DB acti-
vation: displayed in cycles of 10 seconds)
Continued on next page.