• Do not install or store the product in any of the following locations.
• Although machined surfaces are covered with an anticorrosive coating, rust
can develop due to storage conditions or the length of storage.
If you store the product for more than six months, reapply an anticorrosive
coating to machi
ned surfaces, particularly the motor shaft.
• Consult with your Yaskawa representative if you have stored products for an
ex
tended period of time.
• Transport the product in a way that is suitable to the mass of the product.
• Do not hold onto the cables or motor shaft when you move a Servomotor.
• Do not use the eyebolts on a SERVOPACK or Servomotor to move the
machine.
• When you handle a SERVOPACK or Servomotor, be careful of sharp parts,
s
uch as the corners.
• Do not place an excessive load on the pr
oduct during transportation. (Follow
all instructions on the packages.)
E-5
Transportation Precautions
• Locations that are subject to direct sunlight
• Locations that are subject to ambient temperatures that exceed product spec-
ifications
• Locations that are subject to relative humidities that exceed product specifi-
cations
• Locations that are subject to condensation as the result of extreme changes
in temperature
• Locations that are subject to corrosive or flammable gases
• Locations that are near flammable materials
• Locations that are subject to dust, salts, or iron powder
• Locations that are subject to water, oil, or chemicals
• Locations that are subject to vibration or shock that exceeds product specifi-
cations
• Locations that are subject to radiation
If you store or install the product in any of the above locations, the product
may fail or be damaged.
There is a risk of disconnection, damage, or injury.
There is a risk of damage or injury.
There is a risk of injury.
There is a risk of injury or damage.
To Next Page
Loading...
