YASKAWA SI-S3/V Series User Manual

9 Fault Diagnosis and Possible Solutions
YASKAWA ELECTRIC TOBP C730600 24D 1000-Series Option SI-S3/V, SI-S3/T Installation Manual 37
■ Minor Faults and Alarms
LED Operator Display Minor Fault Name
AEr
Setting Address Error
CANopen Option is set to an address outside the allowable setting range.
Cause Possible Solution
Minor Fault
(H2- = 10)
Address outside the specified address
range
⇒ Set F6-35 to an address within the specified range. YES
LED Operator Display Minor Fault Name
CALL
Serial Communication Transmission Error
Communication has not yet been established.
Cause Possible Solution
Minor Fault
(H2- = 10)
Communication wiring is faulty, there
is a short circuit, or something is not
connected properly.
Check for wiring errors.
⇒ Correct the wiring.
⇒ Remove and ground shorts and reconnect loose
wires.
YES
Programming error on the master side
⇒ Check communications at start-up and correct
programming errors.
Communication circuitry is damaged.
Perform a self-diagnostics check.
⇒ Replace the drive if the fault continues to occur.

YASKAWA SI-S3/V Series Specifications

General

Brand	YASKAWA
Model	SI-S3/V Series
Category	DC Drives
Language	English