EasyManua.ls Logo

YASKAWA Varispeed f7

YASKAWA Varispeed f7
463 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-30
d5-04 Speed limit
Set the speed limit during
torque control as a percent-
age of the maximum output
frequency.
This function is enabled
when d5-03 is set to 2.
Directions are as follows.
+: Run Command direction
-: Run Command opposite
direction
-120 to
+120
0% No No No No A 29DH 6-128
d5-05
Speed limit
bias
Set the speed limit bias as a
percentage of the maximum
output frequency.
Bias is given to the specified
speed limit. It can be used to
adjust the margin for the
speed limit.
0 to
120
10% No No No No A 29EH 6-128
d5-06
Speed/
torque con-
trol switch-
ing timer
Set the delay time from
inputting the multi-function
input “speed/torque control
change” (from On to OFF or
OFF to ON) until the control
is actually changed, in ms
units.
This function is enabled
when the multi-function
input “speed/torque control
change” is set. In the speed/
torque control switching
timer, the analog inputs hold
the values of when the
“speed/torque control
change” changes. Always be
sure to allow time for this
process to finish completely.
0 to
1000
0 ms No No No No A 29FH 6-129
Con-
stant
Number
Name Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
MEMO
BUS
Regis-
ter
Page
V/f
V/f
with
PG
Open
Loop
Vec-
tor
Flux
Vec-
tor

Table of Contents

Other manuals for YASKAWA Varispeed f7

Related product manuals