xvi
îš‹ Overvoltage Inhibit Function (SPEC: E or Later Only) ............................................... 6-177
7 Troubleshooting ......................................................................7-1
Protective and Diagnostic Functions............................................................ 7-2
îš‹
Fault Detection ............................................................................................................... 7-2
îš‹ Alarm Detection.............................................................................................................. 7-9
îš‹ Operation Errors........................................................................................................... 7-13
îš‹ Errors During Autotuning............................................................................................. 7-15
îš‹ Errors when Using the Digital Operator Copy Function................................................ 7-16
Troubleshooting.......................................................................................... 7-18
îš‹
If Constant Constants Cannot Be Set........................................................................... 7-18
îš‹ If the Motor Does Not Operate ..................................................................................... 7-19
îš‹ If the Direction of the Motor Rotation is Reversed........................................................ 7-21
îš‹ If the Motor Does Not Put Out Torque or If Acceleration is Slow.................................. 7-21
îš‹ If the Motor Operates Higher Than the Reference ....................................................... 7-21
îš‹ If the Slip Compensation Function Has Low Speed Precision ..................................... 7-22
îš‹ If There is Low Speed Control Accuracy at High-speed Rotation in Open-loop Vector
Control Method............................................................................................................. 7-22
îš‹ If Motor Deceleration is Slow........................................................................................ 7-22
îš‹ If the Motor Overheats.................................................................................................. 7-23
îš‹ If There is Noise When the Inverter is Started or From an AM Radio .......................... 7-24
îš‹ If the Ground Fault Interrupter Operates When the Inverter is Run ............................. 7-24
îš‹ If There is Mechanical Oscillation................................................................................. 7-24
îš‹ If the Torque Generated for the Motor is Insufficient (Insufficient Power)..................... 7-25
îš‹ If the Motor Rotates Even When Inverter Output is Stopped ....................................... 7-26
îš‹ If OV is Detected When the Fan is Started, or Fan Stalls............................................. 7-26
îš‹ If Output Frequency Does Not Rise to Frequency Reference...................................... 7-26
8 Maintenance and Inspection ..................................................8-1
Maintenance and Inspection ........................................................................ 8-2
îš‹
Outline of Free Warranty ................................................................................................ 8-2
îš‹ Daily Inspection .............................................................................................................. 8-2
îš‹ Periodic Inspection ......................................................................................................... 8-2
îš‹ Periodic Maintenance of Parts ....................................................................................... 8-3
îš‹ Procedure for Adjusting Constants after Replacement of Control Board ....................... 8-3
îš‹ Types and Number of Cooling Fans Used in the Drive .................................................. 8-4
îš‹ Cooling Fan Replacement Outline ................................................................................. 8-6
îš‹ Circulation Fan Replacement Outline........................................................................... 8-13
îš‹ Removing and Mounting the Control Circuit Terminal Board ....................................... 8-16
To Next Page
Loading...
Need help?
General