YASKAWA Varispeed f7

10-36
* 7. The factory setting will change when the control method is changed. The flux vector control factory settings are given.
* 8. Only 1 (VT) can be set for 200 V Class 110 kW as well as 400 V Class 220 kW and 300 kW Inverters.
* 9. Setting for 200 V Class Inverters. For 400 V Class Inverters, double the value.
* 10.E1-11 and E1-12 are disregarded when set to 0.0.
* 11.E1-13 is set to the same value as E1-05 by autotuning.
* 12.The values in parentheses indicate factory settings when initialized in 3-wire sequence.
* 13.If the setting is 0, the axis will accelerate to the specified speed over the specified acceleration time (C1-01 to C1-08).
* 14.C6-01 = 1:120 %, C6-01 = 0:150 %
* 15.This constant can be monitored or set only when F is set for C6-02.
* 16.When C6-01 = 1, the upper limit is 120 %.