EXAMPLE :
Writing in decimal mode
Entered data
765
43210
0
WRA
000000000
255WR~
1111111
1 255
g.
Repeat steps b, through f. to write required
data.
If you keep the
m ‘r
7 key depressed,
the cursor will
, CL RTSOR
move column by column in the screen auto-
matically.
h. When data has been written, depress the
INSRT key.
Cursor returns to the position
of setting number normally, this sequence
of operations begins and ends both with
the depression of the INSRT key.
4.3, 6.2 Internal Toggle Switches+
(1) When the eight basic function switches shown
below are omitted from the machine oper-
ator’s station, each function may easily
be turned onioff by the setting operation
from the NC operator panel.
(2) The setting numbers are #6000D7 through
D o of bit display format. By the operation
of the writing of bit display format setting
described above, turn on /off each function.
When “ 1“ is set, the function is turned on.
When “O” is set, the function is turned off.
Display shows that Single Block and Dis-
play Lock are on.
Fig. 4.35 Display of Internal Toggle
Switch Status
Notes :
1.
The internal toggle switch is an optional func-
tion.
Hence, which internal toggle switch is
availabledepends on the controlled machine.
The display for unused toggle switches is
blank. For details, refer to the instruction
manual of the machine in question.
2. When the machine control station is provided
with the switches that turn on and off the
above functions, the state of the switch on
the machine control station is ORed with that
of the operator’s panel to determine the final
ON/OFF state.
Setting
Switches on Resultant
Data
Mac~iiomtrol
I ONIOFF
4. 3.6.3 Setting Data of Decimal Display Format
The following setting numbers have the setting
data of decimal number display format:
#6160
through #6219
?#6500 through #6579
#8600 through #8750
These setting numbers are used for the con-
trol constants of tool lifecontrol and multiple
repetitive cycles.
(1)
a.
b,
c.
Display of setting data (decimal display
format)
The setting data is displayed by the follow-
ing operations:
Depress the SET function key.
Key in the 4–digit settine number and de-
~~L~so~’]key.
press
p:ti~ or
The maximum of 10 lines of setting data in-
cluding the keyed setting number are dis-
played. The cursor is p~sitioned to the
designated setting number.
The setting number designation may be up-
dated by
E.
CLJRS~R or ~“
_. I
~CLJRTSOR
key,
and the screen may be updated by
ml or [,x keY
.
169
To Next Page
Loading...
